Sure, every once in a while, you want to intentionally drill a hole an at angle. Sometimes, compound joinery demands it, or you're going for a stylish, contemporary look on a project.
But most of the holes we drill - I'd hazard to say a good 99% of them - are intended to be drilled straight on, perfectly perpendicular to the surface. You can do this precisely with a drill press, but many makers don't have one, and they require specific set up and work that's small enough to be placed on the table.
So that leaves the cordless drill. A tool that, when balanced on the tip of a drill bit, can be easily canted and slanted off square in every single direction, especially when you're putting force behind it. But the task is not impossible.
Yes, DIYers, you can drill a perfectly 90° hole with a cordless drill. Here's how it's done. … Continue reading on ManMadeDIY.com
source http://www.manmadediy.com/users/chris/posts/4692-how-to-drill-a-perfectly-straight-and-square-hole-without-a-drill-press
No comments:
Post a Comment